Gravitrax.trek.pub
I’m reviewing over 70 GraviTrax add-ons from 7 Etsy shops. In this episode, I review add-ons from Coogelbahn.de. I’m Chris …
source
About admin
Related Articles
Check Also
REVIEW: GraviTrax Junior / My Planet Starter Set – Marble Run for Ages 3-7
This video review of GraviTrax Junior is loaded with Goodies & Freebies! Support my videos …
Which Add-on is your FAVORITE?? 😀😁😍
My favourite gravitrax addon Is the base plate connectors and flextube extention
There is a way to design the cardboard bases to other you just need to design a two part connector.
So first you put in the connector you showed in the video and then flip the board and press another part on the connector. Would require a redesign on the connector.
I love your videos about the 3d prints. Keep up the good work!
Cool
When will Part 2 Come? 🙃
Very interesting review! Thanks a lot! I already have some of the presented add-ons, but now I feel like buying a couple more :-). Steffen owns you one!
Now with the pieces in 3D printing no one stops you anymore !!! 🙃
We await more and more surprising new traks 😁
Marble Catcher looks like a solution to the headaches that I had when marble stopped multiple times 😀
Nice Video. I like every 3D printed part and want to try out as much as possible.
Thanks for the video and the honest opinion!
A few comments:
The rail gun is best installed when it is upside down on the table and the rail is then pressed in evenly.
I have already changed the Marble Catcher 😉
I haven't seen it done the way you used the Marble Kicker. The idea was actually just to let the ball fall on it from above.
If you turn the transfer clips a bit, the magnetic force decreases and the ball goes over with more speed.
RAIL CANNON!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
I've broken a transfer only too many times…
personally, I have no such problems with the gravitax catcher! {I'm not a big fan of 3D printed add-ons anyway, though.}
Part 2 is here!